Yes, see table. 60 and 85 give greater resolution of measurement at these gloss levels (small visible differences in finish = a large difference in gloss value)
Whilst 20 has a smaller measurement resolution, visible differences in gloss can be quantified with the Flex 20.
Home / FAQs / Appearance Measurement / Rhopoint IQ Flex Measurement Advice / ISO2813 recommends surfaces measuring mid to low gloss finishes using 60 and 85 deg. Is the flex 20 suitable for measuring these surfaces?
Table of Contents
Related FAQs
FAQ Categories
ISO2813 recommends surfaces measuring mid to low gloss finishes using 60 and 85 deg. Is the flex 20 suitable for measuring these surfaces?
Related products
AFNOR Viscosity Flow Cup
- 2mm - 8mm orifice diameter
- 15 – 3000 cSt viscosity range
- 25 -150 sec flow times
- Supplied with a certificate of conformity
- Sheen 419/2.5, 419/4, 419/6 & 419/8 equivalent
ASTM D1200 Viscosity Flow Cup
- 2.1mm - 5.8mm orifice diameter
- 10 – 1200 cSt viscosity range
- 30-100 sec flow times
- Supplied with a certificate of conformity
- Sheen 406/1, 406/2, 406/3, 406/4 & 406/5 equivalent
Bespoke cutter die – 1 or 2 of the same shape
Bespoke cutter die - 1 or 2 of the same shape