Using Guided Job Mode

Using Guided Job Mode

Guided mode is designed for repeated, structured measurement routines.

1. Set Job mode = Guided in the My Car menu.
2. Choose Start new job/car (wording depends on firmware).
3. Enter any required identification fields (for example serial number or product ID).
4. TAMS displays the next part to measure on the main screen.
5. Measure and batch as normal; when the batch for that part is complete, TAMS moves on to the next part in the sequence.

Guided mode continues until all parts from the list have been measured, at which point a message such as “Finished” is shown. To repeat the routine for another item, select Start new job/car again.

If a listed part cannot be measured, a long‑press on the relevant key (as defined in the instrument) allows it to be swapped (measured later) or ignored for that job.