Laboratory Measurement Stand

The Rhopoint Aesthetix Lab Stand enables users to take precise, non‑contact measurements of delicate materials and curved surfaces, ensuring accuracy without risking damage or deformation. Curved parts can be manipulated using live view to ensure correct alignment.

Part Number- B8000-010

Procedure for non-contact measurement

The pre-calibrated Aesthetix should be attached to the stand with the standard or small area gloss adaptor attached.

Set Focal Distance

-Place the part (3) to be measured on the stand.
-Wind the part until the bottom plate is in contact with the measurement surface,

Check positioning

-Use the interactive measurement mode to ensure the correct part of the sample is in the FOV, and if measuring gloss that the gloss reflection is in the middle of the sensor. How to measure Surface Brilliance

-Note the height of the laboratory stand z-axis (4)

Remove Base

-Lift the Aesthetix (1) and remove the base, if measuring the gloss of curved parts replace with the non-contact small area gloss adaptor.

-Wind (1) to the correct height (4) z-axis (4)

-Use the interactive measurement mode to check the correct part of the sample is in position, and that the gloss reflection is in the middle of the sensor. How to measure Surface Brilliance

-Measure the sample.