# Using Manual Job Mode

> [!note] 이 페이지는 아직 한국어로 번역되지 않아 영어로 표시됩니다.


Manual mode links batches to names, without enforcing a fixed sequence.

1. Set **Job mode = Manual** in the My Car menu.
2. (Optional) Load a measurement database from SD card so that part names are available.
3. Take measurements and close batches as usual (manual or auto batching).
4. When a batch is closed, TAMS prompts whether to assign a name.
    - Choose a name from the list (for example a part or job ID) or skip naming.

On the main screen, the current job mode is shown at the bottom (for example “Job mode: Manual”) and the selected batch name appears on the top line.