# Using Guided Job Mode

> [!note] Questa pagina non è ancora tradotta e viene visualizzata in inglese.


Guided mode is designed for repeated, structured measurement routines.

1. Set **Job mode = Guided** in the My Car menu.
2. Choose **Start new job/car** (wording depends on firmware).
3. Enter any required identification fields (for example serial number or product ID).
4. TAMS displays the **next part to measure** on the main screen.
5. Measure and batch as normal; when the batch for that part is complete, TAMS moves on to the next part in the sequence.

Guided mode continues until all parts from the list have been measured, at which point a message such as “Finished” is shown. To repeat the routine for another item, select **Start new job/car** again.

If a listed part cannot be measured, a long‑press on the relevant key (as defined in the instrument) allows it to be **swapped** (measured later) or **ignored** for that job.